Filter
Top Products
9. Programmable Features
48
Sending a fax at a
specified time
{#}{2}{5} This feature allows you to take advantage of low-cost calling
hours offered by your telephone company. This feature can be set
up to 24 hours in advance of the desired time.
{0} “OFF” (default)
{1} “ON”
To send a document:
1. Insert the document.
2. If necessary, press {A} or {B} repeatedly to select the
desired resolution (page 31).
3. {MENU} i {#}{2}{5}
4. Press {1} to select “ON”. i {SET}
5. Enter the fax number. i {SET}
6. Enter the transmission start time.
L If you select 12-hour time entry (page 19), press {*}
repeatedly to select AM or PM.
L If you select 24-hour time entry (page 19), the time is set
using 24-hour time entry.
7. {SET} i {MENU}
Note:
L To cancel after programming, press {STOP} then {SET}.
Setting the Caller ID list
to print automatically
{#}{2}{6}{0} “OFF” (default): The Caller ID list will not be printed
automatically, but the base unit will keep a record of the
information for the last 50 callers.
{1} “ON”: The Caller ID list will be printed automatically each time
the base unit logs 50 callers (page 25).
Activating the
Distinctive Ring feature
{#}{3}{1}{0} “OFF” (default)
{1} “ON”
See (page 38) for details.
Setting the quick scan {#}{3}{4} This feature is helpful when you want to remove the document for
other uses, because the unit will release the document before
sending or copying.
{0} “OFF” (default): Deactivates this feature.
{1} “ON”: The unit will scan the document and store it into
memory first, then the unit will start sending or copying the
documents.
Note:
L If the document exceeds the memory capacity, sending of the
whole document or copying of the exceeded document will be
cancelled and this feature will be turned OFF automatically.
Feature Feature code Selection