Filter
Top Products
17
Setup
Initial
Preparation
Recording paper!
Document stacker!
1
Open the cover by pressing the cover open
button and install the recording paper roll.
●
If the paper is secured with glue or tape,
cut approximately 15 cm (6 inches) from
the beginning.
2
Pull the leading edge of the paper
approximately 10 cm (4 inches) out of the
unit.
●
Make sure that there is no slack in the
paper roll.
3
Close the cover securely by pushing down
on both ends.
4
Tear off the excess paper by pulling it
towards you.
Install the document stacker.
Cover open
button
10 cm
Document stacker
Note:
●
Only use the included roll of paper or specified recording paper, or else the print quality may be
affected and/or excessive thermal head wear may occur.
●
For accessory order information, see page 12.
●
When the power cord is connected, everytime you close the cover a message will be printed. If the
recording paper is set to the wrong side, the message will not be printed. Install the paper correctly.
correct
incorrect