Filter
Top Products
36
Configure the settings relating to Panasonic alarm protocol [Panasonic alarm
protocol]
Click the [Notification] tab on the "Alarm setup" page. (☞ page 32)
The settings relating to Panasonic alarm protocol can be configured on this page.
■ Panasonic alarm protocol setup
[Panasonic alarm protocol]
Select "ON" or "OFF" to determine whether or not to
notify of an alarm occurrence by Panasonic alarm proto-
col when an alarm is detected.
Default setting: OFF
Note:
When "ON" is selected, the alarm occurrence will be
notified to the registered destination IP addresses in
order (to IP address 1 first, to IP address 8 last).
[Destination port]
Select a destination port of the Panasonic alarm proto-
col from the following.
Available value: 1 - 65535
Default setting: 1818
[Retry times]
Select a retry time of Panasonic alarm protocol.
Available value: 1 to 30
Default setting: 2
■ Panasonic alarm protocol
[IP address 1] to [IP address 8]
Enter the destination IP address of the Panasonic alarm
protocol from the following. Host name is unavailable for
the IP address. Up to 8 destination addresses can be
registered.
To provide notification at an alarm occurrence to the
desired IP address using Panasonic alarm protocol,
check the "Alarm" checkbox respective to the desired IP
address.
To provide notification using Panasonic alarm protocol
when any of the following has occurred, check the
"Diag." checkbox respective to the desired address.
• When notification of the remaining space of the SD
memory card has been provided (☞ page 21)
• When the SD memory card has become full
• When mounting of the SD memory card has failed
To delete the registered address, click the [DEL] button
respective to the desired address.
Number of characters that can be entered: 1 - 128
characters
Important:
Confirm that the destination IP addresses are regis-
tered correctly. When a registered IP address does
not exist, notification may be delayed.