Filter
Top Products
19
E
4 This screen should appear.
Set the computer’s parameters for wireless LAN functions and TCP/IP.
Set Network Type, SSID, WEP Encryption, IP Address, and NetMask according to the
above screen. (In the above settings, Network Type is shown as “AdHoc” in some cases,
while a term such as “Peer-to-Peer Group” is used here.)
2 Connect the wireless display to a power outlet and turn on
the wireless display. (
page 21)
<Wireless display screen>
Select network type.
AdHoc Infrastructure Cancel
<Wireless display screen>
Change setting on host PC to the following
value, reboot the host PC, then select
"Connect" below.
Connect Cancel
Wireless LAN card
Network Type : AdHoc
SSID : cfvdw07-17498
WEP Encryption : disable
TCP/IP Class A Class B Class C
IP Address : 10. 98.185.105
NetMask : 255. 0. 0. 0
MeiWDS
AES Encryption : disable
Password : wdsp
This screen is a sample.
AES : Advanced Encryption Standard
3
This screen should appear.
Select [AdHoc].
Power Switch
The wireless display will turn off automatically after 10 minutes have elapsed. In
this case, start the procedure from step 2 .
NOTE
5 Select [Connect] on <Wireless display screen> of step 4 .