Filter
Top Products
About Your Projector
ENGLISH - 13
Preparation
J Back and bottom view
NOTE:
Do not cover the ventilation openings or place anything within 50 cm (20") of the vents as this may cause
damage or injury.
This projector should only be used with the attached Power cord to ensure optimum performance and avoid
damage to the projector.
Do not open the Top cover other than replacing the lamp unit.
AC IN
Connect the Power cord to
supply electronic power to
the projector. (page 19)
Security lock
Attach the commercial shackle
lock, manufactured by
Kensington, to protect your
projector. Compatible with the
Kensington MicroSaver Security
System.
SERIAL
Connect a compatible cable
for controlling the projector
remotely via your PC.
PC IN
Connect an RGB signal
cable from your PC.
COMPONENT 2 IN
Connect a YPBPR signal cable.
VIDEO IN
Connect an RCA
composite video cable.
S-VIDEO IN
Connect a S-VIDEO
signal cable.
Connecting
terminals
(page 18)
HDMI IN
Connect HDMI signal cables.
COMPONENT 1 IN
Connect a YPBPR signal
cable.
Air intake port
Air intake port
Top cover
Hold at the back corner of the Top
cover and slightly push up to
open. (page 42)
Front leg adjusters
Screw up/down to adjust the
projection angle. (page 21)
Lens cover attachment hole
PT-AE1000U.book Page 13 Monday, October 16, 2006 1:40 PM