Filter
Top Products
ENGLISH - 19
Basic Operation
Switching the projector on/off
Ensure all the input devices are connected and turned off before connecting the Power cord.
J Connecting
Make sure to use the
Power cord which is
provided with the projector.
1. Ensure the shape of the
power cord plug and the
AC IN connector on the
side of the projector match, then push the
plug all the way in.
2. Connect the Power cord to a wall outlet.
J Disconnecting
Make sure the MAIN POWER is switched off.
1. Hold the plug and unplug the Power cord
from the wall outlet.
2. Hold the plug and unplug the Power cord
from the AC IN connector on the side of the
projector.
Power cord
NOTE:
Do not force the connector as this may damage the projector and/or the power cord.
Dirt or dust build-up around plugs may cause fire or electrical hazards.
Switch off the power to the projector when not in use.
POWER indicator
Indicator status Status
No illumination or flashing The MAIN POWER is switched off.
RED Lit The MAIN POWER is switched on and the projector is in standby.
GREEN
Flashing The POWER is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
ORANGE
Lit The POWER is switched off and the projector is cooling the lamp.
Flashing
The POWER is switched on again when cooling the lamp and recovering
to projection mode. Recovery may take a while.
NOTE:
While the projector is cooling the lamp, do not switch the MAIN POWER off or unplug the Power cord.
The electric consumption in standby mode is 0.08 W.
POWER indicator
PT-AE1000U.book Page 19 Monday, October 16, 2006 1:40 PM