Filter
Top Products
ENGLISH-25
Getting started
24-ENGLISH
To RGB output
Operating range
If the remote control unit is held so that it is facing directly in front of the remote
control signal receptor, the operating range is within approximately 7 m (23´) from
the surfaces of the receptor. Furthermore, the remote control unit can be operated
from an angle of ±30° to the left or right and ±15° above or below the receptor
.
#Open the cover.
$Insert the batteries so that the polarities are correct, and then close
the cover.
NOTE:
BIf the buttons on the remote control unit are kept pressed, the battery
power will be consumed rapidly.
BIf there are any obstacles in between the remote control unit and the
receptor, the remote control unit may not operate correctly.
BIf strong light is allowed to shine onto the remote control signal receptor,
correct projector operation may not be possible. Place the projector as
far away from light sources as possible.
B
If facing the remote control unit toward the screen to operate the projector,
the operating range of the remote control unit will be limited by the amount
of light reflection loss caused by the characteristics of the screen used.
NOTE:
BDo not drop the remote control unit.
BKeep the remote control unit away from liquids.
B
Remove the batteries if not using the remote control unit for long periods.
BDo not use rechargeable batteries.
Preparation for the remote control unit
AA batteries
(two)
Computer
Connecting to computer
Computer for
control use
Serial adapter (ET-ADSER :
sold separately)
DIN 8-pin (male)