Panasonic PT-D5500E Projector User Manual


 
13
ENGLISH
VIDEO IN terminal (page 19)
An input terminal for video signals. (BNC)
S-VIDEO IN terminal (page 19)
An input terminal for S-video signals
(MIN4-pin DIN).
This terminal complies with S1 signals and
automatically toggles between 16:9 and 4:3
according to the size of input signals.
RGB (YP
B
P
R
)1 input terminal (pages 19, 20)
A terminal to input RGB or YPBPR signals (BNC).
RGB (YP
B
P
R
)2 input terminal (page 20)
A terminal to input RGB or YPBPR signals (D-SUB
15-pin female).
DVI-D IN terminal (page 20)
DVI-D signals are applied to this terminal. (24-pin
DVI connector)
LAN terminal (page 37)
This terminal is used to control the projector from
the PC. (10Base-T/100Base-TX compliant)
REMOTE1 lN/OUT terminal (page 16)
When two or more main units are used in the
system, they can be connected and controlled with
a wired remote control cable (M3 jack).
REMOTE2 IN terminal
The user can remotely control the main unit by
using an external control circuit to this terminal
(D-SUB 9-pin female).
SERIAL IN terminal (pages 20, 38)
Use the RS232C serial terminal as an alternative
interface for controlling the projector from your PC
(D-SUB 9-pin female).
SERIAL OUT terminal (page 20, 38)
The signal applied to the serial input port appears
at this terminal (D-SUB 9-pin male).
RGB 2 IN
VD
SYNC/HD
B/P
B
G/Y
R
R/P
SERIAL
REMOTE 1
REMOTE 2 IN IN
OUT
LAN
DVI-D IN
RGB 1 IN
VIDEO IN
S-VIDEO IN
IN OUT
Side-mounted
connection terminals