Filter
Top Products
45
ENGLISH
Insert the power cord plug into the wall outlet and then
press the MAIN POWER switch.
Press the “POWER” button so that a picture is projected
onto the screen.
Press the “MENU” button to display the MAIN MENU
screen, and then press the and buttons to move
the cursor to select “OPTION2”.
Press the “ENTER” button to display the “OPTION2”
screen, and select “SYSTEM INFORMATION” with the
and buttons.
Press the “ENTER” button.
The SYSTEM INFORMATION screen will be displayed.
Press and hold the “ENTER” button on the projector or
the remote control for approximately 3 seconds.
An item “LAMP TIME RESET” will be added.
Select the lamp which has been replaced with the and
buttons.
LAMP1: Replace the LAMP UNIT 1
LAMP2: Replace the LAMP UNIT 2
Press the ENTER button, and when the “LAMP TIME
RESET” display flashes, press the ENTER button again.
The used hours of the specified lamp unit will be reset to zero.
When more than one lamp has been replaced, repeat the procedure from
step .
• If the power does not turn on even after turning the MAIN
POWER switch “I”, turn the MAIN POWER “O”, confirm that
the lamp unit and door are installed correctly, and turn on
again.
Attention
MENU
PICTURE
ADVANCED MENU
OPTI0N2
TEST PATTERN
OPTION1
POSITION
LANGUAGE
LAMP TIME RESET
LAMP1
LAMP2
LAD55
LAD55L
LAD55
1433h
0h
1100h
0h
LAD55L
SYSTEM INFORMATION
ROM VERSION
HIGH
200h
TOTAL
300h
LAMP2 LOW
SET RUNTIME
300h
LAMP1 LOW
100h
100h
1. 00. 00
• When the “LAMP TIME RESET” display flashes, the lamp
time reset can be canceled by pressing the MENU button.
Note