Panasonic PT-D5500E Projector User Manual


 
18
Connection
Setup precautions
Before connecting any of your video/audio equipment to the projector, carefully read the owners manual
supplied with the equipment once again.
All cable connections should be made with the entire system devices, including the projector, first turned off.
Obtain commercial interconnecting cables for devices supplied with no accessory or optional interconnect
cables.
Video signals containing too much jitter may cause the images on the screen to randomly wobble or shake.
Inserting a time base corrector (TBC) in the projectors video line will relieve this problem.
The projector only accepts composite-video, S-video, analogue-RGB (with TTL sync. level), and digital signal
from PC.
Some PC models are not compatible with the PT-D5500E/D5500EL projector.
The pin assignments on the S-VIDEO IN port are as
follows:
The pin assignments on the DVI-D input port are as
follows (interface with TMDS port on PC):
The pin assignments on the RGB2 input port are as
follows:
Viewed from mating side
Pin No.
Signal
Ground (luminance)
Ground (colour)
Luminance signal
Colour signal
Pin : Not used.
Pins - , , and : Ground.
Pins and : Valid if the PC has the
corresponding function.
Viewed from mating side
Signal
R/P
R
G/G · SYNC/Y
B/P
B
SDA
HD/SYNC
VD
SCL
Pin No.
Viewed from mating side
Pin No.
Signal
T. M. D. S data 2-
T. M. D. S data 2+
T. M. D. S data 2/4
shield
T. M. D. S data 4-
T. M. D. S data 4+
DDC clock
DDC data
T. M. D. S data 1-
T. M. D. S data 1+
T. M. D. S data 1/3
shield
T. M. D. S data 3-
Signal
T. M. D. S data 3+
+5 V
Ground
Hot plug sense
T. M. D. S data 0-
T. M. D. S data 0+
T. M. D. S data 0/5
shield
T. M. D. S data 5-
T. M. D. S data 5+
T. M. D. S clock
shield
T. M. D. S clock+
T. M. D. S clock-
Pin No.