Filter
Top Products
E
NGLISH-51
Adjustments and settings
50-E
NGLISH
FRONT/REAR
This setting should be changed in
accordance with the projector
setting-up method.
(Refer to page 20.)
FRONT
When the projector is placed in front
of a screen.
REAR
When using a translucent screen.
DESK/CEILING
This setting should be changed in
accordance with the projector
setting-up method.
(Refer to page 20.)
DESK
When the projector is placed on a
desk or similar.
CEILING
When the projector is suspended
from a ceiling using the ceiling
bracket (sold separately).
HIGHLAND
Set “HIGHLAND” to “ON”, when
using this projector at high
elevations (above 1 400 m) only.
LAMP RUNTIME
This setting displays the usage time
for the lamp unit which is currently
being used. When replacing the
lamp unit, follow the instructions on
page 58, and reset “LAMP
RUNTIME” to “0”.
SXGA MODE
[PC(SXGA) only]
Adjust this item if the projected
image overflows from the screen
when an SXGA signal is being
input.
SXGA
Select this item normally.
SXGA+
When the edges of the projected
image are not visible, select this
item.
CTRL PANEL
To disable the buttons on the
projector, set “CTRL PANEL” to
“INVALID”. A confirmation screen
will then be displayed. Select “OK”
by using I or H button. To use the
buttons on the projector, set to
“VALID” by using the remote control
unit.
NR (Noise Reduction)
(S-VIDEO/VIDEO only)
If the signal is of such poor quality
that picture interference appears,
set “NR” to “ON”. To turn off the
“NR” feature, set to “OFF”.
FRONT/REAR FRONT
[
REAR
DESK/CEILING DESK
[
CEILING
HIGHLAND OFF
[
ON
NOTE:
BThe lamp’s operating life varies
depending on the usage
conditions.
SXGA MODE SXGA
[
SXGA+
Changing the display language
Press the F or G button on the remote control unit to select a language, and
then press the ENTER button to accept the setting.
LANGUAGE SETUP
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
PORTUGUÊS
SELECT ENTER RETRN
LANGUAGE SETUP
SVENSKA
NORSK
DANSK
POLSKI
C
E
S
TINA
MAGYAR
SELECT ENTER RETRN