Filter
Top Products
E
NGLISH-5958-ENGLISH
'Install the lamp unit cover, and
then use a Phillips screwdriver
to securely tighten the lamp
unit cover fixing screw.
(Connect the mains lead.
)Press the POWER button so
that a picture is projected onto
the screen.
*Press the MENU button to
display the “MAIN MENU”, and
then press the F or G button
to select “OTHER SETUP”.
B
A
+
Press the ENTER button to display
the “OTHER SETUP” menu, and
then press the F or G button to
select “LAMP RUNTIME”
.
,
Press and hold the ENTER button
for approximately 3 seconds
.
The “LAMP TIME RESET” screen
will be displayed.
-Select “OK” by pressing the
II
or
HH
button on the remote
control unit and then press the
ENTER button.
The “POWER OFF” confirmation
screen will be displayed.
.Press the POWER button to
turn off the power.
/Disconnect the mains lead
after the POWER button on the
projector illuminates red.
This will reset the cumulative
usage time for the lamp unit to “0”.
MENU
PICTURE ADJUSTMENT
POSITION ADJUSTMENT
OTHER SETUP
LANGUAGE SETUP
SECURITY SETUP
SD PICTURE SETUP
SELECT
ENTER EXIT
NOTE:
BBe sure to install the lamp unit
and the lamp unit cover
securely. If they are not securely
installed, it may cause the
protection circuit to operate so
that the power cannot be turned
on.
NOTE:
BThe “POWER OFF” screen will
disappear in five seconds.
B
If the MENU button is pressed, the
“LAMP TIME RESET” screen and
the “POWER OFF” confirmation
screen will be cancelled.
NOTE:
BIf the mains lead was
disconnected during projection
when the projector was used
the last time, projection will
start after the mains lead is
connected.
Lamp unit replacement procedure
#Disconnect the mains lead
from the projector by following
the procedure on page 28, and
check that the area around the
lamp unit has cooled down.
$Use a Phillips screwdriver to
turn the lamp unit cover fixing
screw at the bottom of the
projector, and then remove the
lamp unit cover.
%Use a Phillips screwdriver to
loosen the lamp unit fixing
screw until the screw turns
freely. Then hold the handle of
the lamp unit and gently pull the
lamp unit out from the projector.
&Insert the new lamp unit while
making sure that the direction
of insertion is correct, and then
use a Phillips screwdriver to
securely tighten the lamp unit
fixing screw.
When inserting the new lamp
unit, be sure to push it in at the
point A and B.
LAMP indicatorOn-screen display
Illuminates red during
image projection and
standby mode.
Displayed for 30
seconds. Pressing any
button will clear the
display.
More than 2 250 hours
Remains displayed until
any button is pressed.
More than 2 500 hours
NOTE:
B
If the lamp usage time has passed 2 500 hours, the projector will switch to
standby mode after approximately 10 minutes of operation. The steps
)
to
/
on the next page should thus be completed within 10 minutes.
Handle
Lamp unit cover
Lamp unit cover fixing screw
Lamp unit fixing screw
OTHER SETUP
AUTO SIGNAL ON
TV-SYSTEM AUTO
FRONT/REAR FRONT
DESK/CEILING DESK
HIGHLAND OFF
LAMP RUNTIME 2300H
SXGA MODE SXGA
CTRL PANEL VALID
NR OFF
SELECT RETRN
LAMP TIME RESET
OK CANCEL
POWER OFF
[POWER] OK
Care and maintenance