Panasonic PT-P1SDE Projector User Manual


 
ENGLISH-13
Preparation
12-ENGLISH
Read this page first
When you turn on the power for the first time after purchase, the
“LANGUAGE SETUP” and “OTHER SETUP” menus will be displayed. Adjust
the settings according to the place and situation where you are using the
projector.
These menus will be displayed only when you turn on the power for the first
time, but you will be able to change the settings by operating the on-screen
menus. (Refer to page 40 for details.)
LANGUAGE SETUP menu
FRONT/REAR
This setting should be changed in
accordance with the projector
setting-up method.
(Refer to page 20.)
FRONT
When the projector is placed in front
of a screen.
REAR
When using a translucent screen.
DESK/CEILING
This setting should be changed in
accordance with the projector
setting-up method.
(Refer to page 20.)
DESK
When the projector is placed on a
desk or similar.
CEILING
When the projector is suspended
from a ceiling using the ceiling
bracket (sold separately).
HIGHLAND
Set “HIGHLAND” to “ON”, when
using this projector at high
elevations (above 1 400 m) only.
$Press the MENU button to
cancel the screen after
adjusting.
OTHER SETUP menu
OTHER SETUP
FRONT/REAR FRONT
DESK/CEILING DESK
HIGHLAND OFF
SELECT
ADJ EXIT
FRONT/REAR FRONT
[
REAR
DESK/CEILING DESK
[
CEILING
HIGHLAND OFF
[
ON
LANGUAGE SETUP
ENGLISH
DEUTSCH
FRANÇAIS
ESPAÑOL
ITALIANO
PORTUGUÊS
SELECT ENTER
LANGUAGE SETUP
SVENSKA
NORSK
DANSK
POLSKI
C
E
S
TINA
MAGYAR
SELECT ENTER
Select the language in which
the on-screen menus will be
displayed by pressing the
FF
or
GG
button on the remote control
unit, and then press the ENTER
button.
BThe confirmation screen will be
displayed.
Press the ENTER button again.
BThe on-screen menus will be
displayed in the selected
language.
BPress the MENU button to
return to the language
selection screen.
#$
LANGUAGE SETUP
ENGLISH
OK RETURN
NOTE:
BThe OTHER SETUP menu
will be displayed in turn
automatically after confirming
the selected language.
#Press the
FF
or
GG
button to
select an item, and then press
the I or H button to change
the setting.