Filter
Top Products
ENGLISH -
17
Preparation
About Your Projector
Remote control
*
<P IN P> Button is only for PT-VW330U.
(1) <AUTO SET> Button
Execute the setting of Auto setup in the setting
menu. (
Æ
page 52)
(2) Input Selection Buttons: <COMPUTER
1>, <COMPUTER 2>, <HDMI>, <VIDEO>,
<S-VIDEO>, <COMPONENT>.
These buttons are used to select the input signal.
(
Æ
page 32)
(3) ▲▼◄► Buttons, <SELECT> Button
Navigate the MENU display. (
Æ
page 36)
(4) <SCREEN> Button
Select a screen mode. (
Æ
page 48)
(5) <MENU> Button
Open or close the On-Screen Menu. (
Æ
page 36)
(6) <FREEZE> Button
Pauses the projected image and sound tentatively.
(
Æ
page 33)
(7) <AV MUTE> Button
Temporarily turn off the image on the screen.
(
Æ
page 34)
(8) <D.ZOOM ▲▼> Buttons
Zoom in and out the images.
(9) <VOLUME> Buttons (+/-)
Adjusts the volume of the speaker. (
Æ
page 34)
(10) <ON/STAND-BY> Button
Turn the projector on or off. (
Æ
page 28)
(11) <KEYSTONE> Button
Correct keystone distortion. (
Æ
page 33)
(12) <INFO.> Button
Operate the information function. (
Æ
page 33)
(13) <LAMP> Button
Select a lamp mode. (
Æ
page 34)
(14) <P-TIMER> Button
Operate the P-timer function. (
Æ
page 34)
(15) <P IN P> Button (Only for PT-VW330U)
Operate the Picture In Picture function. (
Æ
page 35)
(16) <IMAGE> Button
Select the image mode. (
Æ
page 35)
(17) <MUTE> Button
Mute the sound. (
Æ
page 35)
(18) Remote control signal emitter
Attention
Do not drop the remote control.
z
Avoid contact with liquids.
z
Do not attempt to modify or disassemble the remote
z
control.
Note
The remote control can be used within a distance of
z
about 5 m (16.4 ft) if pointed directly at the remote control
signal receiver. The remote control can control at angles
of up to ± 30 ° vertically and ± 30 ° horizontally, but the
effective control range may be reduced.
If there are any obstacles between the remote control
z
and the remote control signal receiver, the remote control
may not operate correctly.
You can operate the projector by reecting the remote
z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receiver is lit with a
z
uorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
(1)
(10)
(2)
(4)
(5)
(6)
(8)
(7)
(9)
(17)
(16)
(15)
*
(14)
(13)
(12)
(11)
(3)
(18)