Filter
Top Products
49
ªState of Power Lamp while
charging
The Power Lamp flashes while charging.
(Flashes approx. every 2 seconds when
charging is normal.)
When the Power Lamps flashes more
quickly or slowly (or turns off), some
abnormality may have occurred.
The flashing speed suggests the following
states.
Flashing approx. every 0.5 seconds:
≥The SD Multi AV Device, battery or AC
adaptor may be defective. Contact your
nearest Panasonic dealer.
Flashing approx. every 6 seconds:
≥The ambient temperature or that of the
battery itself is too high or too low.
Charging proceeds, but will take a longer
time.
Turning off:
Charging is completed.
If the Power Lamp turns off when charging
is not completed, the AC Adaptor or the
Battery is probably defective. Contact your
nearest Panasonic dealer.
Notes and Hints
ª Power Supply (l 10)
≥When the Battery Level Indicator
indicates [ ], the battery will run
out in a few minutes. Recharge the
battery.
≥It takes approx. 120 minutes, maximum
for full-charging. (The charging times are
for normal ambient temperature
(68°F(20° C) /60%). If the Battery is
charged at a higher or lower temperature,
the charging time may be longer.)
≥The capacities of the recording time/
playback time/still picture storage with a
supplied, full-charged battery are as
follows (68°F(20°C) /60%):
The times/number of images listed in the
above table are approximate.
≥If you disconnect the DC Input Lead or the
AC Main Lead while charging the Battery,
Power Lamp flashes several times and
goes off. For continuing Battery charge,
wait for approx. 1 minute, and then
connect the AC Main Lead and the DC
Input Lead.
≥It is recommended to set the battery even
when using the AC adaptor.
≥The main unit becomes hot when it is
being charged or used. This is normal.
≥When removing the battery, take care not
to drop it.
≥When the SD Multi AV Device is turned
on, do not attach or remove the battery, or
plug the power cord in or out.
ª Inserting a Memory Card (l 11)
≥While the Card Access Lamp is on, the
following operations should not be
attempted: (Such action will damage the
Memory Card, cause loss of recorded
data and cause the SD Multi AV Device to
malfunction.)
-Remove or insert the Memory Card.
-Remove the battery or unplug the power
cable.
-Apply vibration or shock.
≥An SD Memory Card can be used for this
SD Multi AV Device.
≥Do not touch the terminals on the back of
the Memory Card with your fingers.
Number of Recordable Still Pictures
(PICTURE)
1200
Maximum Continuous Recording Time
(MPEG4)
90 min.
Maximum Continuous Voice
Recording Time (VOICE)
180min.
Maximum Continuous Music Playback
Time (MUSIC)
(When the [POWER SAVE] function is
activated)
180 min.