Filter
Top Products
58
5: During Playback an [k] Indication is
displayed.
5: The data was either recorded in a
different format, or data is damaged.
6: Even if a Memory Card is formatted,
it cannot be used.
6: Either the SD Multi AV Device or the
Memory Card may be damaged.
Please consult your Panasonic dealer.
7: Playing back or recording do not
function and the screen has frozen.
7: Set the Power/Mode Switch to [OFF]
and then set it back to [REC] or [PLAY]
after a while (approx.1 minute). If the
SD Multi AV Device is not turned off
after setting to [OFF], unplug the AC
Adaptor and remove the battery.
8: Sound is not heard while a still
picture is played back.
8: Sound is not presented in the Still
Picture mode (recording or playing
back of still pictures).
Others
1: How do I send an MPEG4 moving
picture recorded as e-mail?
1: Capture the moving picture data
recorded on the SD Multi AV Device
onto a personal computer and attach it
to an e-mail to send it. In this case, it is
recommended to make a file size 1 MB
or less. The recording time of 1 MB
MPEG4 moving picture is approx. 8
seconds (SUPER FINE), 15 seconds
(FINE), 20 seconds (NORMAL) or 60
seconds (ECONOMY). (The capacity
limit of the file which is attachable to an
e-mail differs depending on the
environment used.) If the file is played
back on the personal computer,
Windows Media Player 6.4 or later is
required. If the file is played back on
Macintosh, use the Windows Media
Player for Macintosh. (Mac OS
®
8.0 or
later) The Windows Media Player for
Macintosh can be downloaded from
Microsoft’s Web site.
2: Red, blue, green or white dots
appear on the screen.
2-1: 0.01% or less of the pixels of some
LCD Monitors may remain turned on or
off.
2-2: If the SD Multi AV Device is used
continuously for a long time or used at
a high ambient temperature, red, blue,
green or white dots may appear on the
screen and be recorded on a still
picture. This is due to the rise of the
temperature inside the body. This is
caused by a characteristic of the C-
MOS sensor and is not a failure. Under
this condition, turn the SD Multi AV
Device off and leave it for a while.
≥C-MOS sensors are said to be a
next-generation image pick-up
device succeeding CCDs as they
are small and consume low
amounts of power.
3: When the USB cable is connected, a
green [?] mark is indicated in [USB
Mass Storage Device] in [Device
Manager] of the Windows OS.
3: If the USB cable is connected without
installing the USB Driver (supplied), [?]
will be indicated on some OSs.
Remove the USB cable from the SD
Multi AV Device and install the USB
Driver according to the procedure
shown on page 38, and [?] will
disappear.
4: When the USB cable is removed
when Windows Me is used, Device
removal warning appears.
4: If the USB cable is connected without
installing the USB Driver (supplied)
when you use Windows Me, the
warning message will appear as soon
as the USB cable is pulled out. Install
the USB Driver, and the warning
message will not appear.
For how to disconnect the USB cable
on Windows XP or Windows 2000,
refer to page 41.