Filter
Top Products
Switching the projector on/off
Basic Operation
20 -
E
NGLISH
POWER and POWER LOCK indicators
The POWER indicator informs you of the status of the power and the POWER LOCK indicator shows the status
of the RELEASE button. When the TEMP indicators are ashing, the POWER and POWER LOCK indicators will
light red and you cannot switch the projector on.
POWER indicator
POWER LOCK indicator
J
POWER LOCK indicator status
Indicator status Status
No illumination or ashing
No power is supplied.
z
The
z
RELEASE button is pressed and the POWER button is unlocked while
the power is on.
Red
Lit The POWER button is locked.
Flashing Pressing the locked POWER button.
J
POWER indicator status
Indicator status Status
No illumination or ashing No power is supplied and the internal cooling fan is not operating.
Red
Lit
The power is turned off (when STANDBY MODE is set to ECO).
If the POWER button is pressed, projection starts.
Flashing The power is turned off (when STANDBY MODE is set to NORMAL).
Green
Flashing The power is on and preparing for projection.
Lit The projector is projecting.
Orange
Lit
No power supply and the internal fan is cooling the lamp by internal power
supply.
Flashing
The power is switched on again while cooling the lamp and recovering to the
projection mode. Recovery may take a while.
Remarks
When the power is turned off, the internal fan is cooling the lamp by internal power supply.
z
The power is switched on again while cooling the lamp and recovering to the projection mode. Recovery may
z
take a while.
Even while the power is turned off (when
z
STANDBY MODE is set to ECO, the POWER indicator is lit in red),
power of about 0.9 W is consumed.