Filter
Top Products
Switching the projector on/off
Basic Operation
E
NGLISH - 21
Switching on the projector
Before switching on the projector, make sure the power cord and all the other devices are connected correctly.
(
Æ
page 17)
INPUT SELECT
RELEASE
POWER indicator
POWER LOCK indicator
(2)
(3)
Connect the power cord. 1 ) (
Æ
page 19)
The POWER LOCK indicator and POWER indicator light in red.
Press the RELEASE button to unlock the POWER button.2 )
The POWER LOCK indicator goes off.
When operating with the remote control, you do not need to press the
z
RELEASE button.
Press the POWER button.3 )
The POWER button beeps once.
You can turn
z
ON
or
OFF
the beeping sound that occurs when you press the
POWER
button by menu setting.
(
Æ
page 41)
The
z
POWER indicator ashes in green several times, then the POWER indicator lights up and the
STARTUP LOGO is displayed. See “STARTUP LOGO” in the “DISPLAY OPTION” menu.
(
Æ
page 37)
Note
Operating the control panel buttons with covered hand, such as plastered or gloved, may result in operating
z
errors.
Remarks
Conrm that
z
CONTROL PANEL (when operating with the projector body) or REMOTE CONTROLLER
(when operating with the remote control) under CONTROL DEVICE SETUP in the SECURITY menu is set to
ENABLE. (
Æ
page 44)
The projector does not operate when the
z
POWER button of the projector body is pressed while it is locked.
If the
z
POWER button is not being pressed in 10 seconds after the RELEASE button is pressed, the POWER
LOCK
indicator lights in red and the
POWER
button remains locked. Press the
RELEASE
button again to unlock.
When starting up the projector, some small rattling or tinkling sound may be heard. Those are normal and will
z
not affect the performance of the projector.
When the internal cooling fan is operating, some operational sound may be heard. The loudness of the
z
operational sound depends on the external temperature.
If
z
INITIAL START UP in the PROJECTOR SETUP menu is set to ON, the projector starts projecting when the
power cord is connected to a wall outlet. (
Æ
page 39)
If the projector is switched on again while the internal cooling fan is still operating by the internal power supply,
z
the display may icker for the characteristics of the lamp. Those are normal and will not affect the performance
of the projector.