Panasonic TQBJ0302 Projector User Manual


 
POSITION menu
Settings
E
NGLISH - 33
OVER SCAN
Use this function when characters or pictures are
cropped near the periphery of the projected image.
(Available with signals of S-VIDEO/VIDEO/RGB
(Moving image)/YP
B
P
R
only)
Zoom out
Zoom in
Setting range: 0 to +3
z
Remarks
OVER SCAN
z
is not available when network signals
are input.
ASPECT
You can switch the aspect ratio manually when needed.
Selectable options vary according to input signal.
Change setting
Change setting
AUTO 4:3 16:9
THROUGH H FIT
S4:3 HV FIT V FIT
Remarks
AUTO
z
mode is displayed only when NTSC 480i
signal is input.
THROUGH
z
mode is displayed only for certain
signals.
For the wide signal *
z
2
, the aspect ratio cycles
through 16:9 V FIT HV FIT.
AUTO
J
(Available with signal of NTSC 480i only)
The signal which contains an identifying signal
will be detected and will automatically project the
image in the most optimal aspect ratio.
4:3
J
When a standard signal *
1
is input, it is projected
in 4:3 aspect ratio.
Input signal: XGA
z
Image:
16:9
J
When a standard signal *
1
is input, it is projected
in 16:9 aspect ratio.
When a wide signal *
2
is input, it is projected in the
current input aspect ratio.
Input signal: 1 080/60i
z
Image: Panel:
H FIT
J
When a standard signal *
1
is input, it is projected
without changing the aspect ratio, using all the
panel pixels in the horizontal direction and
cropping the top and bottom of the image.
Input signal: SXGA
z
Image:
V FIT
J
When a wide signal *
2
is input, it is projected
without changing the aspect ratio, using all the
panel pixels in the vertical direction and cropping
the right and left of the image.
Input signal: 1 080/60i
z
Image:
HV FIT
J
The image is projected all over the panel pixels
(screen). The input signal is projected at the
aspect ratio of the panel (screen).
Input signal: 1 080/60i
z
Image:
A standard signal has an aspect ratio of 4:3 or 5:4.*1:
A wide signal has an aspect ratio of 16:10, 16:9 or *2:
15:9.