Filter
Top Products
Customizing Your Machine
38
Fax Parameter Table
34 ENERGY SAVER
MODE
1 Off To reduce the power consumption in standby, select either
Energy-Saver or Sleep mode and specify the Delay Time
(1 to 120 minutes) for the machine to enter into the
selected mode.
The Delay Timer setting is only available in the Energy-
Saver or Sleep Modes.
Off : The unit will remain in standby
mode and consume more energy
than when in Energy-Saver or
Sleep modes.
Energy-Saver Mode: Saves energy by consuming less
power than when in standby mode
by turning off the fuser unit after
the specified time.
Sleep Mode : This is the lowest power state that
the machine enters after the
specified time without actually
turning off.
2 Energy-
Saver
*3 Sleep
35 DAYLIGHT TIME 1 Invalid Selecting whether the clock adjusts for Daylight Saving
Time automatically. The built-in clock will advance 1 hour
at 2:00 am on the first Sunday in April and fallback 1 hour
at 2:00 am on the last Sunday in October.
*2 Valid
36 RING PATTERN
DETECT (DRD)
(See Note 2)
*1 Invalid All ring patterns.
2 Valid Select a ring pattern for automatic answering.
1: A Standard ring pattern.
2: B Double ring pattern.
3: C Triple ring pattern (Short-Short-Long).
4: D All other triple ring patterns, except the
type C described above.
37 RCV TO MEMORY (----) Enter a 4-digit password used to print out the received
document in memory by using F8-5 (RCV TO MEMORY).
When F8-5 is set to On, this parameter will not be shown
on the LCD display. (See page 92)
38 ACCESS CODE (----) Enter a 4-digit Access Code to secure the machine from
unauthorized use. (See page 90)
39 PIN CODE ACCESS *1 None Selecting the access method (Prefix or Suffix) to dial a
number with PIN Code. (See page 97)
2Suffix
3Prefix
42 CONF. POLLED FILE
SAVE
*1 Invalid Selecting whether the machine saves the confidential
polled file even after the file is polled once.
2Valid
43 PASSWORD-XMT *1 Off Setting a 4-digit XMT-Password and selecting whether the
machine performs and checks the XMT-Password of the
receiving station when transmitting. (See page 102)
2On
44 PASSWORD-RCV *1 Off Setting a 4-digit RCV-Password and selecting whether the
machine performs and checks the RCV-Password of the
transmitting station when receiving. (See page 103)
2On
46 SELECT RCV *1 Invalid Selecting whether the machine performs selective
reception. (See page 100)
2Valid
47 REMOTE RECEPTION 1 Invalid Selecting whether or not the machine accepts remote
reception command. (See page 63)
*2 Valid
No. Parameter
Setting
Number
Setting Comments