Filter
Top Products
External Signal Type Selection (DSW3-6, DSW3-7). Selects the type of output
signal.
Repeat Print via External Signal (DSW3-8). Allows an external device to control
the reprint of the label in the print buffer.
RS232 Transmit/Receive Setting (located on RS232C I/F Module)
The PTR3E comes standard with a parallel port only. Contact Product
Management if serial port is required.
Data Bit Selection (DSW1-1). This switch sets the printer to receive either 7 or
8 bit data bits for each byte transmitted.
Parity Selection (DSW1-2, DSW1-3). These switches select the type of parity used
for error detection.
Stop Bit Selection (DSW1-4). Selects the number of stop bits to end each byte
transmission.