Filter
Top Products
2. Once the correct setting is underlined, pressing
the FEED key will accept the setting and
advance the display to the Print Offset display.
Vertical Offset is the distance down from the leading edge
(the edge of the label that comes out of the printer first) to
the first vertical print position. A positive setting moves
the first print position down the length of the label.
Horizontal Offset is distance that the label image is
shifted to the right or left on the label. The image is
shifted to the left (towards the inside edge of the label for a
right-hand printer) for a positive setting and it is shifted
to the right (towards the outside edge of the label) for a
negative setting. The setting changes the base reference
point for all subsequent label jobs. It’s effect is identical to
the <ESC>A3 Base Reference point command. Since the
printer moves the label in discrete steps equal to the size
of the print dot, the units of measure for Vertical and
Horizontal Offset distance is dots. The maximum values
that can be set for each is +/-800.
1. Use the LINE key to step the first digit of the
counter to the desired setting. The display will
increment one step each time the LINE key is
pressed.
2. Press the FEED key to accept the setting and
advance the cursor to the second digit. Again use
the LINE key to step to the desired setting.
Once it is correct, pressing the FEED key will
step to the next adjustment.
3. Once the setting is correct, pressing the FEED
key will accept the setting and advance to the
next display.
You may wish to print a test label after completing the
adjustments to ensure they are correct.
Note: This setting can be overridden by the Base
Reference Point Command
This selection tells the printer to strip out all carriage
return/line feed repairs (CRLF) from the data stream,
including graphics and 2D bar codes.
1. Use the LINE key to step the underline cursor to
either the YES or NO selection.
2. Once the correct setting is underlined, pressing
the FEED key will accept the setting and
advance the display to the Character Pitch
display.
PRINT OFFSET
V:+0000 H:+000
IGNORE CR/LF
YES NO