Filter
Top Products
4. If the printer did not beep and print a status label, turn
the printer off and check your data stream for errors
and start the download process over.
5. If the custom codes are correct, press the FEED key to
accept them and terminate the download process. If
they are incorrect, turn the printer off without pressing
the FEED key and begin the process again.
HEX DUMP MODE
In addition to the User Test Print Labels, the printer can print the contents of the receive buffer
in a hexadecimal format to allow the data stream to be examined for errors and
troubleshooting.
The Hex Dump Mode is entered by placing DSW2-4 in the ON
position and powering the printer on.
1. The printer is now ready to receive data.
2. Send the data stream to the printer.
3. The received data will be printed in a hexadecimal
format
4. To return the printer to normal operation, place
DSW2-4 in the OFF position and power the printer off
andthenbackon.
POTENTIOMETER ADJUSTMENTS
PITCH
After the pitch has been set with the LCD Control Panel, it is sometimes desirable to
make minor adjustments. This can be done using the PITCH potentiometer on the
front panel. This potentiometer is set at the factory so that it has a range of +/-3.75
mm. The midpoint setting should have no effect on the pitch. Turning the
potentiometer all the way clockwise should move the print position 3.75 mm up
towards the top edge of the label. Turning it all the way counter clockwise should
move the print position down 3.75 mm.
1. While depressing the FEED key on the front panel, power the printer on.
2. When you hear one beep from the printer, release the FEED key and the
printer will display on the LCD panel a message asking what type of Test
Label you want to print.
3. Use the LINE key to step to the Configuration selection and press the FEED
key to accept the selection.
4. Use the LINE key to select the Test Label size. After the size is selected,
press the FEED key to accept the selection and the printer will begin to print
test labels continuously.
5. Adjust the PITCH potentiometer on the front panel until the first print
position is at the desired location on the label. If the potentiometer does not
ROM V00.00.00.00
INITIALIZING
ONLINE
QTY:000000