Filter
Top Products
Standards Compliance for SNMP Traps
D-4
7612-A2-GB20-10November 1997
The tests that affect the enterpriseTestStart, enterpriseTestStop, and the
variable-binding are different for each particular interface. Diagnostic tests are
only supported on the physical DDS network and user data port interfaces. The
specific tests and variable-bindings are described in the following table:
Interface
enterpriseTestStart/Stop
Variable-Bindings
Possible Cause
Physical Sublayer
DDS network H ifIndex (RFC 1573)
H ifAdminStatus
(RFC 1573)
H ifOperStatus (RFC 1573)
H ifType (RFC 1573)
H ddsTestType (DDS
Enterprise MIB)
H enterpriseTestStart – Any one
of the following tests is active
on the interface:
– DSU Loopback
– CSU Loopback
– Send 511 pattern
– Monitor 511 pattern
H enterpriseTestStop – No
longer has any tests running
on the interface.
Synchronous User
Data Ports
H ifIndex (RFC 1573)
H ifAdminStatus
(RFC 1573)
H ifOperStatus (RFC 1573)
H ifType (RFC 1573)
H ifTestType (RFC 1573)
H ifTestType – Any one of the
following tests is active on the
port:
– Local Loopback (DTE)
– Send 511 pattern
– Monitor 511 pattern
H ifTestType – No longer has
any tests running on the port.