Filter
Top Products
Hotwire Menus and Screens
2-11
8000-A2-GB26-10
January 1999
The status of each DSL card is indicated by codes displayed in any of eight
positions to the right of the card selected.
The following table explains the valid codes by position.
Column
Heading
Position Display Description
Slt <slot number> M = MCC card
1–18 = slot number for DSL card
Mdl # <card type> First four digits of the card model number:
8310 = MVL card
8510 = RADSL card
8000c = MCC card (conservative)
Stat
1 T or _ Test mode. Card currently in test mode or _ for
no active test.
2 M or _ Major alarm. Major alarm present on card or _
for no active major alarm.
3 R or _ Minor alarm. Minor alarm present on card or _
for no minor alarm active.
Eth 4 U, D, or X Status of Ethernet link:
U=Up, D=Down, X=Disabled
DSL Lnk 5, 6, 7, & 8 U, D, X, or H Status of DSL card Port 1–4 link:
U=Up, D=Down, X=Disabled, or
H=Handshaking
WAN Lnk For future Use.
For example, if you select DSL card in Slot 1, the following may be displayed:
1: 8510 _M_D UXXX
Position: 1234 5678
This display shows the following:
H There is an 8510 card in Slot 1
H Position 1 – No current test ( _ )
H Position 2 – Major alarm is present (M)
H Position 3 – No minor alarm present ( _ )
H Position 4 – Ethernet link is Down (D)
H Position 5 – DSL port 1 is Up (U)
H Positions 6, 7, and 8 – DSL ports 2, 3, and 4 are disabled (X)
On the Card Selection screen, there is a prompt used to select a specific card in
the DSLAM chassis. When a DSL slot number is entered, you are connected to
the card you selected.