Filter
Top Products
8310 MVL and 8510 RADSL Card Configuration
4-12
8000-A2-GB26-10
January 1999
Table 4-4. Bridge Options (2 of 3)
Client VNID A-E-D
Gives the user the ability to configure static clients on VNIDs. Up to 32 entries per port
(static users, DHCP users, or subnets) are allowed. Multiple screens are required to
completely configure the port.
For a list of VNID, press Ctrl-v.
DSL Port # – Enter the DSL port number 1–4 (Default = 1).
Item – Enter 0 to add a new client or enter an existing entry number to edit this entry.
IP Address – For single users, enter the client IP address in
nnn.nnn.nnn.nnn
format
(Default = none). There must be an entry in this field. Typically, all IP addresses in the
same VNID would be on the same subnet.
NOTE: For additional information, refer to
Configuring Subnet Masks
in Chapter 3,
Configuring the Hotwire DSLAM.
Subnet Mask – For multiple users with IP addresses in the same subnet, enter both the
IP address and the subnet mask in
nnn.nnn.nnn.nnn
format.
CAUTION: The same subnet cannot be assigned to multiple ports. An error
message will appear if the IP address of the next hop router is not in the
same subnet as the client IP address. Geographically dispersed clients
are supported through static host-specific entries only.
NHR – Enter the IP address of the next hop router in
nnn.nnn.nnn.nnn
format, if
different than the default for the VNID (Default = none).
VNID – VNID ID between 2–4094 (This field is read-only.)
Type – S = Static or D = Dynamic (This field is read-only.)
NOTE: If a DHCP response cannot be added to the host table because it already
has 32 entries, and if IP scoping/filtering has been enabled on the Card
VNID screen (A-E-B), any subsequent upstream packets from that host are
dropped.