Filter
Top Products
3. Configuration Options
3-100 December 2002 9000-A2-GB31-00
Default Gateway Address
Possible Settings: 001.000.000.000 – 223.255.255.255, Clear
Default Setting: Clear (000.000.000.000)
Specifies the IP address for the port’s default gateway. It is used for packets that do not
have a route.
001.000.000.000 – 223.255.255.255 – Shows the IP address for the port, which can be
viewed or edited (i.e., a router on the LAN).
Clear – Fills the default gateway’s IP address with zeros.
Proxy ARP
Possible Settings: Enable, Disable
Default Setting: Disable
Determines whether the FrameSaver unit will use the Proxy ARP (Address Resolution
Protocol) technique, acting as the gateway to other FrameSaver devices in its
management network when there is an ARP request for a device not on the Ethernet.
Enable – Proxy ARP is enabled on the port so the FrameSaver unit will act as an agent
for or gateway to other units in its management network. Using this technique, the
FrameSaver unit returns its own MAC (Media Access Control) address in response to
ARP requests when it recognizes that the destination IP address is in its subnet, but the
device sending the ARP request is in another network. Packets sent to the FrameSaver
unit’s gateway address are forwarded to the appropriate device.
Disable – The Proxy ARP technique will not be used by the unit; it will not act as an agent
for other devices in its network.
Table 3-37. Ethernet Management Options (2 of 2)