Filter
Top Products
7. DTE Controlled Remote Digital Loop
Select Option 7 in the Menu to
enable DTE control of the Remote Digital Loop Menu (See below). The
interface by selecting Enable (Option 1). To instruct the 1092A to
ignore this request from the DTE interface, select Disable (Option 2).
Select Option 8 in the SOFTWARE CONFIGURATION
configure 2-Wire or 4-Wire operation.
MAIN MENU Option 5: Select Hardware/Software Control
MAIN MENUselects whether the Model
settings for its active configuration. If Options 1 or 2 are selected, the
1092A will use the current hardware or software switch settings as the
Option 8 to implement the changes.
*******************************************************
*
2-Wire/4-Wire Selection
*
*
1. 4-Wire Mode
*
*
2. 2-Wire Mode
*
* *
*******************************************************
MAIN MENU Option 6: Display Modem Status
Select Option 6 from MAIN MENU to display the Modem Status
(below). Press the space bar on the keyboard to update and redisplay
the screen.
NOTE:Valid Model 1092A Handshake Statuses are listed below:
1) Handshaking - This status occurs when the 1092A is in the
process of establishing a link with another 1092A.
2) Data Mode - This status occurs when the 1092A successfully
establishes a link with another 1092A allowing the data to flow.
MAIN MENU Option 7: Test Modes
Select Option 7 from the MAIN MENU to select the test mode status
of the Model 1092A. (below). The Model 1092A Test Mode settings
help to verify the integrity of the data link and isolate communication
difficulties.
NOTE:Test Mode options 2,3,7,8 and 9 require the 1092A to be in
Data Mode with the remote 1092A.
18