Filter
Top Products
Model 2977 PT1 PT2 adapter installation 32
Model 2977 DialFire RAS User Manual 3 • Installing the Model 2977 adapter
6. Write down the serial number of the adapter in the space provided below. The serial number label has the
general form: “S/N (S) XXX XXXXX”
Serial Number: ________________________
7. Insert the adapter into the slot and screw the endplate to the computer chassis.
8. Replace the computer’s cover.
9. Connect the PRI line(s) to the adapter. If the adapter is a RAS PE1, only Line 1 (see figure 5 on page 31)
is active. If the adapter is a RAS PE2, two PRI lines are supported and both connectors may be used.
Adapter installation is complete. Refer to Chapter 4, “Driver installation and configuration”.
Model 2977 PT1 PT2 adapter installation
The DialFire RAS PTE Series adapters provide one or two 30B+D PRI interfaces in a package that fits in a sin-
gle PCI slot in your server.
Because it uses DSP (digital signal processor) technology, the DialFire RAS adapter supports digital or analog
connections on PRI circuits. The adapter supports up to 30 channels on each line.
The position of the PRI connectors is shown in figure 6.
Note
Line 1 and Line 2 connectors are present on RAS PT1 and RAS PT2
adapters, but only Line 1 is active on RAS PT1 adapters. A RAS PT1
adapter may be field-upgraded to RAS PT2 by the addition of a
daughter card
Figure 6. PT1 & PT2 Connector Locations
Do the following:
1. Unplug power from the computer.
2. Remove the computer’s cover.
Line 2
Line 1
Green LED
Yellow LED