Filter
Top Products
05/08 Rev. AB OPERATOR’S HANDBOOK Setup
9844/9854
2-8
Loading Fan-fold Material
Follow these steps to load fan-fold
material:
1. Open the cover.
2. Release the printhead pressure lever (1).
3. Position the fan-folded material behind the
printer (Fig. 1).
4. Guide the material over the material
unwinder. Push the material guide up to
the edge of the material without pinching
the material.
5. Slide the light barrier fitting using the grip
(6) until the pointer (7) is located above the
material perforations (Fig. 2).
¯ The optional reflex sensor is located
5mm to the right of the pointer below the
material!
6. Thermodirect printing: Close the pressure
lever. Thermotransfer printing: See
“Loading Ribbon” to continue.
1
2