Filter
Top Products
05/08 Rev. AB OPERATOR’S HANDBOOK Setup
9844/9854
2-10
Dispensing (Peel) 9854 only
1. Follow the steps for loading material from
the previous section. Then, follow these
steps.
2. Remove the labels from the first 10 inches
(25 mm) of backing paper (Fig. 1).
3. Press the red button (1) at the dispensing
edge to release the peel roller (Fig. 1).
4. Remove the peel roller, feed the label web
through as illustrated (Fig. 1) and press
the roller back between its bearings.
5. Thread the backing paper backwards to
the takeup reel (2) as shown (fig. 2).
6. Wrap the end of the backing paper
clockwise around the takeup reel (2) and
secure it with the clip (3).
7. Turn the takeup reel counter-clockwise
until the backing paper is pulled tight.
After turning on the printer, the reel rotates
slowly until the material web is pulled tight
(Fig. 3).
You may see
before the material is pulled tight.
« If this happens, press Online to clear the
message. You may need to press it several
times.
Status 5004
Rewinder mat. tear
1
2
3