Filter
Top Products
05/08 Rev. AB OPERATOR’S HANDBOOK Setup
9844/9854
2-13
Material/Ribbon End
Material Stock End
If the material end has passed the material sensor, you see
« Release the pressure lever and pull the end of the remaining material from the
front side of the printer.
Ribbon End
If the ribbon roll is emptied (the ribbon unwind reel is not turning), you see
« See “Loading a Ribbon” to continue.
¯ Ribbon end detection can be turned off for theromodirect printing.
« To do so, set the parameter SYSTEM PARAMETERS > Ribbon autoecon. to
Thermal printing.
P Refer to the “Info-Printouts and Parameters” section on your CD-ROM for
more information.
Status 5002
Material end
Status 5008
Ribbon end