05/08 Rev. AB OPERATOR’S HANDBOOK Safety
General safety notes
« Keep these operating instructions in a safe place and make sure they are
read.
« The printer must be operated, adjusted and serviced by instructed and
authorized personnel.
« Carefully follow all procedures listed in this manual.
Service Special servicing, error searching and error correction are to be performed by
authorized personnel.
CAUTION! - The printer operates safely when you observe all necessary
information.
« Proper operation of the product requires the user to read and follow these
operating instructions. The warranty does not cover service required as a
result of operator error and/or failure to read and follow the documentation.
WARNING! - Any changes or modifications not expressly approved by us
could void the user's authority to operate the equipment.
« Only operate the printer using the system voltage indicated on the
nameplate!
« Only connect the printer to a grounded power outlet.
« Only use the printer within specified environmental conditions!
« Only operate the printer when the cover is closed!
« Only trained and authorized personnel should operate the printer!
« During operation, the printhead can become hot! Be careful when touching
the printhead!
« Do not make any modifications to the printer!
« Do not spill any liquids into the printer!
« Repairs to the device must be performed by authorized specialists!
« Before cleaning the printer, turn off the printer and disconnect the power
supply!
« Only use original accessories!
« Connect the printer only to other devices that fulfil SELV (safety extra-low
voltage) circuit requirements to EN 60950!
Keep long hair, loose jewelry, long sleeves, etc. away from the printer
during operation.
« Wear sufficient personal protection gear.
The printer can only be disconnected completely by removing the power
supply cable. For this reason:
« Make sure that the printer’s power supply socket is readily accessible!
« In case of emergency, turn off the printer and disconnect the power supply
cable!