Paxar AAFES Printer User Manual


 
2-8 User Manual
Setting the Print Position
This function adjusts where data prints vertically on the supply. Adjust
the print if it is too close to the top or bottom of the supply, or
overtypes the pre-printed area. The adjustments are in dots (0.0049
inch). The range is -99 to +99 and the default is 0.
If the data is too close to the bottom, increase the number.
If the data is too close to the top, decrease the number.
1. From the Config Menu, press or until you see
12. Set Print Position
2. Press Enter. You see
Enter print pos
[-99/99] +0
3. Press or to change the contrast in increments of 1 dot.
Press or to change the contrast in increments of 10 dots.
Pressing or decreases the value (moves the image down);
or increases it (moves the image up).
4. When you are finished, press Enter. You return to the
Config Menu.