Filter
Top Products
6-2 Equipment Manual
Problem Solution
The display does not turn on.
Make sure the power is on.
Switch to a fully-charged battery.
An error code and
corresponding message
appears on the display.
See your System Administrator.
Error Codes
Following are some common error codes you may receive.
Code(s) Description
004 – 005 Supply size is incorrect. Reload the correct supplies.
267 – 271
410 – 413
Communication error. See your System Administrator.
703 – 704
Supply Error. Load supplies or make sure they are loaded
correctly.
750 Printhead is overheated. Turn off the printer to let it cool.
751 – 753
The printer sensed a problem with a mark on the supplies.
Check the supplies to see if they are loaded correctly.
756 The printer is out of supplies. Load supplies.
757
Load supplies. The calibrated supply length differs by plus
or minus .25 inches from the format.
758
Supply error. Check for a label jam. Clear the supply path
or reload supplies.
762 Low battery. Recharge the battery.
763 Waiting to dispense label. Press Enter.
768 Printhead error. See your System Administrator.
790 – 791
The printer is busy or has an error pending. Turn off the
printer. Wait two seconds and turn it back on.
904 – 911 System error. See your System Administrator.
SYSTEM
ERROR
VECTOR ##
System error. See your System Administrator.
If these solutions do not work or you have a problem or error code not listed,
see your System Administrator or call Service at the number listed on the
back of this manual