Filter
Top Products
42
5.3.3 DHCP Server
This topic describes how to configure the DHCP server feature on your ADSL/Ethernet
router.
Adding DHCP Server Address Pools:
1. If the DHCP Server Configuration page is not already displaying, click the LAN tab, and
then click DHCP Server in the task bar.
Depending on your pre-configured settings, the table may display up to two address pools,
each in a row, or may be empty.
2. Click Add. The DHCP Server Pool - Add page displays.
3. Enter values for the Start IP Address, End IP Address, and Net Mask fields, which are
required, and any others as needed:
z Start/End IP Addresses: Specify the lowest and highest addresses in the pool, up to a
maximum range of 254 addresses.
z Mac Address: A MAC address is a manufacturer-assigned hardware ID that is unique
for each device on a network. Use this field only if you want to assign a specific IP
address to a specific computer (that is, you are creating an exception to the dynamic
assignment of addresses). The IP address you specify will be assigned to the computer