Filter
Top Products
77
corresponding ppp, eoa, or other WAN interface.
(4) Select a metric value for the interface
RIP uses a "hop count" as a way to determine the best path to a given
destination in the network. The hop count is the sum of the metric values assigned
to each port through which data is passed before reaching the destination. Among
several alternative routes, the one with the lowest hop count is considered the
fastest path
(5) Select a Send Mode and a Receive Mode.
The Send Mode setting indicates the RIP version this interface will
use when it sends its route information to other devices.
The Receive Mode setting indicates the RIP version(s) in which
information must be passed to the ADSL/Ethernet router in order for it
to be accepted into its routing table.
RIP version 1 is the original RIP protocol. Select RIP1 if you have
devices that communicate with this interface that understand RIP
version 1 only.
RIP version 2 is the preferred selection because it supports
"classless" IP addresses (which are used to create subnets) and other
features. Select RIP2 if all other routing devices on your LAN support
this version of the protocol.
(6) Click Add. The new RIP entry will display in the table.
(7) Click the Enable radio button to enable the RIP feature
(8) Click Submit. A page displays to confirm your changes.
5.7.3 Firewall
The software provides built-in firewall functions, enabling you to protect the system
against denial of service (DoS) attacks and other types of malicious accesses to your LAN.
You can also specify how to monitor attempted attacks, and who should be automatically
notified.