Filter
Top Products
29
SunTouch Pool and Spa Control System Installation and User’s Guide
Pump Menu (12/13)
From the Pump menu you can setup SunTouch to operate a single-speed pump, or assign up to four circuits to
a two-speed pump or an IntelliFlo 4 pump. You can also assign four custom speeds (RPM) for the IntelliFlo 4
pump.
Single speed filter pump
For a single-speed pump there are no circuit assigned. The pool filter pump schedule program determines
when the pump is switched on and off. If the heat source is enabled in the “Heat” menu (see page xx), when
the pool or spa circuit is activated the selected heat source is also enabled. The default time before the filter
pump will switch off is 12 hours. If the pool/spa circuit is switched off and the heater is operating, only the
heater will turn off, then the filter pump will automatically switch off after 10 minutes to allow the heater to
cool down. Pentair heaters do not require a cool down time. To override the “heater cool-down,” press the
Filter Pump button again to switch off the pump.
To select a single-speed pump.
Menu button: Select the Pumps menu.
Right button: Press the button to select the pump settings.
Up/Down buttons: Select Single Speed. A single-speed pump has no assigned
circuit. The pool filter schedule determines when the pump is switched on and off. For
more information, see Schedules Menu on page 17.
Right button: Press this button to exit to the main menu items.
Left button: Press the Left button to return to the main status screen.
Two-speed filter pump
For a two-speed filter pump, a two-speed relay installed must be assigned as AUX 1, AUX 2 or AUX 3 so that
the pump will operate at low speed when required.
Assigned circuits will automatically switch a two-speed filter pump to high speed when these circuits are
switched on setup in the Schedules menu. If a two-speed pump is assigned to solar, a cleaner or a pump, when
activated the pump will automatically run for five minutes in high speed then switch to low speed. For
example, when on, the filter pump will switch to high speed whenever the JETS or CLEANER is on. Note:
There must be a two-speed relay installed in the SunTouch enclosure in order for the “Two-Speed”
pump menu feature to work.
Menu button: Select the Pumps menu.
Right button: Press the button to select the pump settings.
Up/Down buttons: Select Two Speed.
Right button: Move to the circuit settings for a two-speed pump. You can assign up
to four circuit to the pump.
Up/Down buttons: Select up to four circuit to the pump. The circuit selections are:
None, Spa, Pool, AUX 1, AUX 2, AUX 3, SOLAR, HEATER, and FREEZE.
Right button: Move to the second circuit settings for the pump. Use the UP/DOWN
button to select the circuit. If necessary, repeat this process to assign the third and
fourth circuit for the pump.
Left button: Press the Left button to return to the main status screen.
Pump Type
[SINGLE SPEED]
Main Menu 12/13
Pumps
Pump Type
[TWO SPEED ]
Pump Circuits
1 - [SPA ]
Main Menu 12/13
Pumps