Filter
Top Products
37
SunTouch Pool and Spa Control System Installation and User’s Guide
Section 2
Installation and Setup
SunTouch System Installation Steps Summary
The recommended SunTouch system installation steps are:
Review, prepare and install SunTouch Power Center (pages 44): Review high voltage connections.
Prepare and install the SunTouch Power Center at the equipment pad. AC power for SunTouch should be
provided from the main-panel circuit breaker located at the house.
Remove SunTouch Power Center knockouts, install conduit and low voltage wire to the Power
Center (page 48).
Install Auxiliary Relays and Valve Actuators (page 53-55): Install auxiliary relays, valve actuators,
and connect actuator cables to the SunTouch motherboard (VLV A, VLV B, or VLV C).
Install Temperature Sensors and Heat Thermostat (page 56): Install water and air sensors.
Connect sensor cable plugs to the SunTouch motherboard.
Optional Equipment - Connecting IntelliChlor and IntelliFlo 4x160 pump (page 51): Connect the
IntelliChlor and IntelliFlo 4x160 communication cable to the SunTouch motherboard to connector COM
PORT.
SunTouch System Start-up (page 60): Perform a system start-up procedure.
Setting up SunTouch after equipment installation via main menu (page 61): Configure the
SunTouch control panel via the main menu for installed equipment.
Required Tools
• 3/16 in. diameter drill (for mounting the SunTouch Power Center)
• 5/16 in. diameter drill (for mounting water temperature sensor)
1
2
3
4
5
6
7