Filter
Top Products
UltraPort Serial Adaptors User Guide
Installing under Windows NT
Page 32
Chapter 2 Installing drivers and host cards
Installing under Windows NT
The procedure for installing and configuring host cards, drivers software and associated
utilities for the Windows NT operating system is as follows:
1. Install any UltraPort and UltraPort SI cards, cables or connector boxes you require into
your system. See
Installing host cards and cable accessories on page 94.
2. If required, remove any host cards you want from your system. See Removing host
cards on page 100.
3. Use the PortDirector software to update your system with the revised number and type of
host cards. See The PortDirector user guide part number 5500028 for further details.
Your system can now use the serial adaptor cards you have installed.
Note
The Perle PortDirector software contains drivers for the UltraPort and UltraPort SI host
cards only.
You will need to install the PortDirector for Windows NT on your system in order to use
the UltraPort and UltraPort SI host cards.
See the PortDirector user guide part number 5500028 for further details.