Filter
Top Products
UltraPort Serial Adaptors User Guide
Installing under SCO UnixWare
Page 69
Chapter 2 Installing drivers and host cards
5. In the Modify Serial Port window, set the parameters shown in the next table
6. In the Modify Serial Port window, click on the Port settings button.
The Port settings window is now displayed.
7. In the Port settings window, select the Data bits and Parity values you require and click
on OK.
8. In the Modify Serial Port window, click on OK to accept the changes you have made and
close the window.
9. Repeat steps 3. to 8. until you have configured the serial ports for all the host cards you
require.
10.In the Serial Manager menu click on Host > Quit to quit Serial Manager and close the
window.
Parameter Set to
Port Type Select either Local Terminal or Modem
Configure port incoming only
Speed the speed value you require
Note
Because the system does not support the selection of speeds above
115200
bps, lower baud rates have been permanently remapped to support
higher port speeds. Remapped speeds are shown in the next table.
Selected speed (bps) Actual speed (bps)
50 230400
75 460800
110 921600