Filter
Top Products
Perle PoE/PoE+ Ethernet Media Converter
Installation Guide
17
2. The SFP module may be inserted before or after applying
power to the media converter
3. Proceed with cable connections.
4. Ensure the SFP module is properly seated.
5. The SFP module may be inserted before or after applying
power to the media converter.
6. Proceed with cable connections.
Using SFP’s with SGMII Interfaces
This media converter
*
is able to operate with SFP’s that utilize an
SGMII interface. This feature is enabled on the S-1110P-SFP
model through the hardware strapping listed below.
• To set SGMII Interface support on SFP port one, strap pins 1
and 3 on jumper J3 (see diagram below).
• To set SGMII Interface support on SFP port two, strap pins 4
and 6 on jumper J3 (see diagram below).
*
SFP’s with SGMII Interface support are on models where the last
5 digits of the serial number begins with the number 17 or greater.
Installing the Duplex Fiber Cable
1. Locate a 1000Base-X compliant duplex (2 strands) fiber cable
with appropriate connectors.
2. Connect the fiber cables from one media converter to the
other media converter/switch/fiber device ensuring that the RX
and TX are reversed (crossed) at the opposite end.