Filter
Top Products
Items from DVR Configuration page
14
6.2 Other Configuration
6.2.1 Allegiant Status Message Monitors
The <Allegiant Status Message Monitors> area is used to
specify the Allegiant monitors that will display ADIM warning
and error messages. Enter the monitor number(s) separated by
commas (monitor ranges are specified with dashes). The monitor
number(s) must exist in the Allegiant Monitor Table.
NOTE for Allegiant model LTC 8500:
• All Allegiants EXCEPT the LTC 8500 display the ADIM
messages on a third line above or below the two status lines.
• The LTC 8500 does not have a third line for these messages,
however, the messages can be set to overwrite the Monitor
Title display. To do this the monitors must be set to
Monitor Title mode.
6.2.2 Auto-Login
If the Enable Automatic Login checkbox is checked, upon start
of the application, ADIM is automatically logged on with User
Privileges.
6.2.3 Keyboard / Com Port Assignment
Example: Connect keyboard 1 into physical port 1 on back of the
serial hub (preconfigured as COM5), etc.
Table
Heading
Explained Field Values
ADIM
Keyboard
Logical
Keyboard
Number
1 – 6
COM
Port
Specify a
com port
for each
keyboard
1 – 256
(See Section 4.3 for
pre-configured values)
• COM port OK (GREEN)
• COM port not available (RED)
ITEM Explained Default
Hi-Q Number
Identifies 1 to 800 Hi-Qs
(Not changeable)
Not
applicable
IP address Hi-Q IP address
000.000.000.000
Primary, Monitor
Review or Backup
Determines how the Hi-Q is
configured into the system
(Primary, Backup, Review)
Primary
Enabled Status Used to bring a Hi-Q online Disabled
Allegiant Input
connected to Hi-Q
MON A output
Must be a valid logical camera
number within the Allegiant
document
Blank
Hi-Q (Hi-Q) input
number
Physical inputs on the Hi-Q
(Not changeable)
Not
Applicable
Allegiant Logical
Camera Number
looped with primary
Hi-Q input
The logical camera number
within the Allegiant system that
is assigned to the physical input
of the Primary Hi-Q
Blank
Allegiant Logical
monitor number
connected to backup
The logical monitor output of
the Allegiant that is assigned to
the physical input of the backup
Hi-Q
Blank