Filter
Top Products
25
English
• [PCM] - The audio device does not support
multi-channel format. Audio is downmixed to
two-channel sound.
• [Bitstream] - Select the original audio to
experience Dolby or DTS audio (BD-video
special sound effect is disabled).
Note
Ensure that the audio format is supported by the disc •
and the connected audio device (amplifier/receiver).
When
• [Bitstream] is selected, interactive audio like
button sound is muted.
[PCM Downsampling]
Set the sampling rate for PCM audio output from
the DIGITAL OUT jack (coaxial/optical).
• [On] - PCM audio is down-sampled at 48kHz.
• [Off] - For BD or DVD recorded in LPCM
without copyright protection, two-channel
audio signals up to 96 kHz are output as LPCM
signals with no conversion.
[Speaker Setup]
Optimize the surround output for the connected
speaker system.
• [Speaker layout] - Activate the test tone for
the speakers and the subwoofer.
• [Speaker Distance] - Set the delay time for
the speakers and the subwoofer if they are
placed closer to the listening position, so that
the sound output from all speakers reach the
listening position at the same time.
• [Speaker Volume] - Set the volume level of
the speakes and the subwoofer to get the ideal
audio balance.
• [Speaker Size]
Set the speaker size for the speakers and •
the subwoofer.
Select • [Large] size for speakers that can
produce low frequency signal below 120
Hz.
Select • [Off] if there is no speaker
connected.
If the front speakers are set to • [Small],
the subwoofer setting is [On] by default.
If the subwoofer is set to • [Off], the front
speakers settings are [Large] by default.
Tip
The test tone is emitted from the speaker while adjusting •
the volume level.
Allow 1ms setting for every 30cm distance between the
•
speaker and the listening position.
4 Select an option, and press OK.
5 Select a setting, and press OK.
To return to the previous menu, press •
.
To exit the menu, press •
.
[Night Mode]
Increase a soft sound level such as dialogue to
make it easier to hear at a low volume, while
simultaneously decreasing a loud sound level.
• [Auto] - Detect and select a best sound level
at a low volume. Applicable to tracks with
Dolby TrueHD audio only.
• [On] – For quiet viewing at night.
• [Off] – For surround sound with a full dynamic
range.
Note
Applicable only to Dolby encoded DVD-video or BD- •
video.
[Neo 6]
A post processing by DTS to generate a surround
sound effect from 2 channel audio.
• [Cinema] – Enable Neo 6 post processing to
the cinema mode.
• [Music] - Enable Neo 6 post processing to the
music mode.
• [Off] – Disable Neo 6 post processing.
[HDMI Audio]
Select an HDMI audio output when you connect
this player and the TV/audio device with an HDMI
cable.
• [Bitstream] – If the connected HDMI
device supports the appropriate HD audio
decoder,the original audio format on the disc is
sent. Otherwise, LPCM is sent.
• [Auto] – Detect and select the best supported
audio format automatically.
[Digital Audio]
Select an audio format for the sound output from
the DIGITAL OUT jack (coaxial/optical).
• [Auto] - Detect and select the best supported
audio format automatically.
English
EN