Filter
Top Products
32 / 58
Main port interface
Change RS232
baud rate
Outputs
state
and flow
control
Change
disconnection
timeout
Inputs state
and voltage
Change IP
address of the
module
Change
subnet mask
of the module
Scan I2C
bus
Number of
bytes to
read from
I2C
Module MAC
address
Change
module
name
Hex data to
write to
Bytes received from I2C I2C operation
I2C Address
The configuration interface allows the user to change the device’s settings.
RS232 baud rate: The user can change the RS232 baud rate and enable or
disable the hardware flow control (CTS/RTS).
TCP timeout: The user can change the number of seconds allowed
before TCP port is disconnected. This feature avoids the
problems due to the crash of a TCP client (PC).
IP address: The user can change the IP address of the module.
Subnet mask: The user can change the subnet mask of the module.
MAC address: Mac address of the module (cannot be changed).
Name: Module name.
The Inputs state and voltage are simply obtained with a click on the
corresponding “Read” button.
The Outputs state and the analog threshold are send to the device with a
click on the corresponding "Write" button.
FMod-TCP User Manual v.2.8