Filter
Top Products
Windows 95 Setup 2-5
Figure 2-3 non–Plug and Play BIOS Detected Screen
To install the NIC using the 3Com Installation Wizard Express
installation option, see the EtherLink III ISA Network Interface
Card Quick Guide that shipped with the 3C509B NIC. To set up
the NIC for installation using the 3Com Installation Wizard Custom
installation option, go to the next section.
Configuring the NIC in a Plug and Play PC
This section describes how to set up your system environment
when installing the NIC in a Windows 95 PC that has a
Plug and Play BIOS installed.
Follow these steps to configure the NIC:
1 Turn the power on and boot Windows 95.
The New Hardware Found screen appears. Then the Update
Device Driver Wizard screen is displayed, as shown in Figur
e 2-4.
Figure 2-4 Update Device Driver Wizard Screen