Filter
Top Products
Full — Normal
Full (full)
A 4:3 picture is enlarged in the horizontal di-
rection only, enabling you to enjoy a 4:3 TV pic-
ture (normal picture) without any omissions.
Normal (normal)
A 4:3 picture is displayed normally, giving you
no sense of disparity since its proportions are
the same as that of the normal picture.
p Different settings can be memorized for
each video source.
p The same setting is automatically applied
for the following grouping.
! SD, USB, iPod
! AV1 and AV2
! EXT1 and EXT2
p When video is viewed in a wide screen
mode that does not match its original as-
pect ratio, it may appear differently.
p Remember that use of this system for com-
mercial or public viewing purposes may
constitute an infringement on the author’s
rights protected by the Copyright Law.
p The navigation map and the rear view cam-
era picture is always viewed at Full.
Switching the sound muting/
attenuation
You can select the muting method when the
navigation guidance is output. This setting is
also effective for a mute signal that has been
received from the MUTE lead connected to the
navigation system.
p When you use a cellular phone connected
with Bluetooth technology (dialing, talking,
incoming call), the AV source volume is al-
ways muted independently of this setting.
p When the voice recognition mode is acti-
vated, the AV source volume is always
muted independently of this setting.
% Touch [MUTE Input/GUIDE] on the “AV
Settings” menu.
= For details, refer to Displaying the “AV Set-
tings” menu on page 142.
Each touch of [MUTE Input/GUIDE] changes
the settings as follows:
! MUTE — Muting
! ATT — Attenuation
! Normal — Volume does not change
p Operation returns to normal when the cor-
respond action is ended.
Setting the rear output
The navigation system’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch Rear SP to Sub W,
you can connect a rear speaker lead directly to
a subwoofer without using an auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (Full).
1 Touch [Rear SP] on the “AV Settings”
menu.
= For details, refer to Displaying the “AV Set-
tings” menu on page 142.
2 Touch [Rear SP] to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select Full.
When a subwoofer is connected to the rear
output, select Sub W.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting is ef-
fective for rear speaker leads only.)
Acquiring iPod music information
This navigation system tries to acquire the in-
formation needed to operate iPod with voice
commands in advance. It may take a short per-
iod of time to transfer the information if there
are many entries in the iPod. Change the set-
ting according to your usage.
The navigation system starts acquiring music
information when the iPod is connected or
when the system boots up while the iPod is
connected.
p If you do not use iPod, this setting is unne-
cessary.
Customizing preferences
En
144
Chapter
25