Filter
Top Products
Basic Operation
30
Deinterlace
This function allows you to determine the type of incoming video content-film, static interlaced
video and moving interlaced video. Different algorithms are applied for each of the content types.
Press
W or X button to set the deinterlace mode.
• DCTI: This function is useful to enhance video by replacing the edges of the video with edges
that have steeper rise and fall times. DCTI turns sloped or sinusoidal waveforms into
rectangular or square waveforms with the same duty cycles and peak-to-peak amplitude. It's
useful for 4:1:1 video sources. The range is from 0 to 7.
• Video on film (VOF): This function is used to identify video artifacts while in film mode. VOF
attempts to repair the artifacts using the low-angle interpolator while remaining in film mode.
• Film Mode: Reproduces the image of the film source clearly. Displays the optimized image of
film transformed with 3:2 pull down (NTSC and PAL60Hz)or 2:2 pull down (PAL 50Hz and
SECAM) enhancement to progressive mode images.
Note:
In PAL50Hz or SECAM, the 2:2 pull down enhancement will be enabled only in film mode, after
the film source has been entered.
Reset
Press button to return to the default setting.
Lamp Timer Reset
The projector keeps a record of the total time the lamp has been in use. You should reset the timer
after you install a new lamp. The total lamp usage time is shown in the Status Screen.
Press button to reset the lamp timer.
Source Assign
Press
W or X button to assign the source to the remote control source buttons. Different source
buttons can share the same source. See the defaults as shown below:
Status
Press button to view current status.
Item Description
ENTER
ENTER
ENTER