Filter
Top Products
Operation
Planar PD8130/PD8150 Installation/Operation Manual 57
PREL
I
MINA
R
Y
Logo Display: This controls whether or not the Planar logo appears during
startup.
Power On Chime: This controls the audible chime at startup.
ControlSelect Control from the Main Menu to set various options related to control of
the projector.
1 Key / 2 Key / 3 Key / 4 Key / 5 Key: These menu items assign the function of
the keys numbered 1 through 5 on the remote.
There are eight sources corresponding to the eight connections to the
projector. When you assign a source to a numbered key, the projector
immediately goes to that source when the key assigned to it is pressed.
If the chosen source is disabled via the Source Enable menu (refer to page 54),
this setting has no effect.
M1 Key / M2 Key / M3 Key: These menu items assign which memory setting to
recall when the M1, M2 or M3 key on the remote is pressed.
Trigger 1: Select Trigger 1 from the Control menu to specify when the Trigger 1
port outputs 12 volts. There is a three-second delay before activation to prevent
operation while selecting an aspect ratio.
• Lamp causes the port to output 12 volts whenever the lamp is on.
• 16:9 causes the port to output 12 volts whenever the 16:9 aspect ratio is
chosen.
• Letterbox causes the port to output 12 volts whenever the Letterbox aspect
ratio is chosen. The output stops if PIP is enabled (PIP source is set to anything
other than off).