Filter
Top Products
Remote Monitoring Network Setup
66 Planar UltraRes User Manual
Remote Monitoring Date and Time
Use this page to change date and time information as needed.
1 Set the date and time manually in the box under the Manual Date and Time
section. The date format is very exact. Fill in the current date and time using
exactly the format shown on the page. Click Set date and time.
2 If you want to have the server periodically check the time from a network source,
fill in the NTP server name or address, and poll interval in the Date and Time
Server section. Click Apply new date and time server settings.
Note: If you don’t have a preferred NTP server, then pool.ntp.org is a good choice for most
installations.
3
Carefully read the instructions in the Local Time Zone section. Fill in the text box
and click Set time zone.
Note: The start and end of daylight saving time default to the first Sunday of April and the
last Sunday of October. As of 2007, U.S. locales that observe daylight saving time must enter
start and end dates in this section. For example, EST5EDT,M3.2.0,M11.1.0 is correct for U.S.
Eastern time zone as of 2007.